Filter
Top Products
Switch Panel 20
Switch Panel
RAISE CUTOUT OVERRIDE SWITCH (optional)
Your truck may be equipped with automatic cutout of
raise at selected lift heights.
To raise past the cutout height, push the optional Raise
Cutout Override switch while, at the same time, pulling
the raise/lower lever toward you (see page 25).
Caution:
Make certain the forks, load and load backrest
will clear all overhead obstructions.
WORK LIGHT SWITCH (optional)
FLASHING LIGHT SWITCH (optional)
Power On & Off
19 Power On & Off
KEY SWITCH
• To start the truck you must be seated, with both feet
on the floorboard (not on any of the pedals), and all
controls in neutral.
• Turn the key clockwise to ON (green dot). Check that
all display lights are working.
• When leaving the truck, turn the key counterclockwise
to OFF (red dot) to shut the truck off.
POWER PEDAL
Push the power pedal with your left foot. If you are
properly seated and the key is turned ON, the steering
pump will start running and you can operate the truck.
If you remove your foot from the power pedal while
driving, power is cut to all truck operations except for
braking and steering.
POWER DISCONNECT
Push the power disconnect button down to cut power
to the truck.
Use the power disconnect to shut the truck down any
time it isn't working right. Don't use the truck if it's not
working right. Report the problem to your supervisor.
Pull the power disconnect button up to reconnect the
battery.
USER CODE (PIN number)
A user code (Personal Identification Number) may be
required. Your company will issue it to you and instruct
you on its use.