Filter
Top Products
7
OPERATING INSTRUCTIONS - ALARM
Prior intrusion Alert
This system will notify you if the alarm was triggered while you were away. Upon disarming, there will be four
additional siren chirps after the two normal disarm chirps. Check your vehicle for any signs of a break in or
tampering. Also, see LED Diagnostics (page 15) to determine the cause of the trigger.
Remote Panic Protection
To sound the alarm in an emergency situation or to draw attention to your vehicle, press and hold the Lock
button for at least 3 seconds until the siren / horn sounds. Press the Unlock button to reset panic mode. The
LCD display will flash most of the icons and emit 10 beeps when the Panic Mode is triggered.
Selective Shock Sensor Disable
To arm the alarm and bypass shock sensor protection, press the Lock Button as normal then press and
release the Lock & Unlock Button together within 2 seconds. You will hear 3 extra siren chirps indicating the
shock sensor bypass for this arming cycle only. This is feature useful when parking near railroad tracks,
airports, or areas with excessive loud machinery or noise to prevent the nuisance of unnecessary false
alarms.
Open Door Alert / Bypass
Upon arming, this system will warn you 60 seconds later if a door is left open. The LCD pager will vibrate and
beep (5X’s) along with displaying the open zone on your LCD screen. This zone will be bypassed until the
door is closed; otherwise, the alarm will continue to protect all other zones.
Pre-Warning Shock Protection
The Pre-Warning (Warn-A-Way) feature will activate when a low-level shock or vibration is detected by the
system’s shock sensor. The alarm will chirp the siren 5 times and flash the lights once to help deter any
further tampering with the vehicle. The pager / remote will beep and show a Hammer Icon.
Passive Arming Mode: (Programmable)
Passive (automatic) Arming occurs 30 seconds after the ignition is turned off and the last door is closed.
Upon closing the last door, the unit will flash the lights twice and LED will be flashing rapidly to confirm passive
countdown. If a door is reopened within the 30-second period, the countdown stops and begins again when
the door is closed. Passive arming provides failsafe protection in case you forget to arm the system.