Filter
Top Products
10
CONVENIENCE AND SAFETY FEATURES
VALET MODE / STARTER DISABLE OVERRIDE
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet
mode. The remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key
to the ON position, press and hold Program/Valet switch for 5-6 seconds. The LED will turn on solid and the
system is now in valet. Perform this procedure again to exit of Valet mode. The keyless entry will still function
normally while in valet mode. In the event of a lost or broken transmitter, perform this step to override the
Starter Disable (if installed).
ANTI-GRIND / STARTER DISABLE (Optional, relay not included)
This Optional feature prevents the user from accidentally grinding the starter if the Ignition key is turned too far to the start
position while engine is already running from the remote starter. The Anti-Grind/Starter Disable requires the use of an external
relay. This system must be programmed to allow the relay to work as a starter disable.
Driver’s Door Priority For EZ-55DP II only (Optional, additional part may be needed.)
When using the optional separate driver’s and passenger unlock function, press and release button #2
(Unlock symbol) on the transmitter to unlock driver’s door only, then press the #2 button again within 2-4
seconds to unlock remaining doors. This feature is optional and requires additional parts and/or labor.
HOOD OPEN SAFETY (Requires grounding hood pin installation)
Prevents the engine from being Remote Started when hood is open and will shut OFF the engine if opened
during while remote started. Eliminates risk of injury to someone working under the hood of the vehicle with a
properly working hood pin installed. If Remote Start button is pressed with the hood open, the lights will flash
once and the unit will not attempt a start.
BRAKE PEDAL RESET
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents unauthorized tampering.
This circuit shuts the system down immediately when brake pedal is pressed if the key is not in ignition and turned to the ON
position.
OEM ALARM INTERFACE
This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start and keyless
entry (if needed for your vehicle). This feature will maintain the original integrity and security of your vehicle’s factory equipped
systems before, during, or after remote start.
NOTE:
When changing, charging, or jumpstarting the vehicle’s battery we recommend removing the main power
fuses located on the heavy gauge RED wires near the remote start module.