Filter
Top Products
7
REMOTE ENGINE STARTING Cont. (Infinity Run Mode)
INFINITY RUN MODE – EXITING THE VEHICLE:
1) With vehicle engine running with the key, **press the Remote Start button for at least 1/2 second, pause a
few seconds, then press and release the remote start button a second time.
2) Parking Lights will start flashing, and doors will unlock.
3) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running.
4) The vehicle’s parking lights will flash for the programmed run time of 12, 24, or 36, or 48 minutes and then
switch to solid while motor runs indefinitely or until fuel supply runs out.
SELECTABLE HOURLY COLD-START MODE (1- 4 HOURS)
This mode allows the vehicle to be programmed to self-start every 1, 2, 3 or 4 hours and run for the
programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a
concern. THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA! Once this mode is set,
the unit will start at the programmed hourly interval and run for the programmed run time. To reset this mode,
start the vehicle with the key or the remote control.
SELECTABLE HOURLY COLD-START MODE – EXITING THE VEHICLE:
1) Engine should be running with the Key. ** Press the Remote Start button for at least 1 second. Lights will
turn on signaling the remote start has turned on and doors will unlock.
2) Within 10 seconds press and release the valet/program button once for each hourly increment (1 time =
1hour, 2X = 2 hours, 3X = every 3 hours, 4X = every 4 hours).
3) Parking Lights will turn once the button is pressed and flash for each consecutive button press.
4) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running.
5) Once outside the vehicle, press and release the remote start button to turn off engine. The parking lights
will flash the number of times indicating the hourly increment for confirmation.
6) The vehicle will start by itself at the selected hourly increment until driven with key or started via the remote
control.
**Programmable for ½ second press or double press. This option is
selectable by your installer.