Crimestopper Security Products CS-2100 Automobile Alarm User Manual


 
WIRING
VIOLET WIRE: (+) DOOR TRIGGER INPUT
Same as GREEN wire [below] except this wire is used for vehicles that show a positive voltage (12 volts) when the
door is open such as many Ford, Lincoln, Mercury vehicles.
BLUE WIRE: (-) HOOD/TRUNK INPUT
This wire is an input trigger for a grounding hood or trunk pin switch. Connect to existing hood and trunk pin switches
that read ground when open. If no existing switches are available, install new pin switches. Note: DO NOT mount new
pin switches in water pathways.
GREEN WIRE: (-) DOOR TRIGGER INPUT
Identify the wire that reads Ground when any door is open and 12 volts when all doors are closed.
YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS
Connect to an ignition wire (or fuse in the fuse box) that shows +12 Volts when the key in both “On” and “Start”
positions.
BROWN/WHITE WIRE: (-) HORN HONK OUTPUT (Optional, May Require Relay)
This wire provides a pulsed (-) negative output for honking the vehicle’s horn when the system is tripped or when panic
is activated. Connect this wire to Negative Horn trigger wire in the steering column or to a relay on vehicles with a
positive horn circuit.
WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (15 Amp Fuse)
Connect to switched parking light wire at back of light switch. If this is not possible, connect directly to one of the
parking lights at the front of the vehicle. European vehicles require separate right and left circuits. Use a dual relay or
2 diodes to separate the output signal.
BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
Connect to RED siren wire.
RED WIRE: +12V POWER INPUT (15 Amp Fuse)
Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the vehicle
battery positive terminal.
BLACK WIRE: SYSTEM CHASSIS GROUND
THIS WIRE MUST BE CONNECTED TO CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt from
the connection point to ensure a good connection. We recommend the kick panel area for your ground point.
2 PIN PLUG (WHITE): PROGRAM/OVERRIDE PUSH BUTTON
2 PIN PLUG (RED): LED INDICATOR (RED FLASHING LIGHT)