Filter
Top Products
3
TRANSCEIVER / PAGER-REMOTE
PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send and
receive information from the vehicle. The Control Module
transmits High Frequency FM signals from the vehicle to your
over long distances. Your range will vary depending on
location, terrain, and local RF noise/interference. This
system is not guaranteed to page you if you are behind
concrete walls, underground, in a large structure, or in an
area with high levels of electronic interference. Handle the
pager/remote with care if the LCD display and/or the
electronics may be damaged if subjected to abuse. The AAA
Cell 1.5V alkaline battery can easily be replaced by sliding
open the battery access door on the back of the remote.
Battery life will vary depending on usage. The LCD screen
will display a low battery icon when the battery is low. For
more on range, see “Range Questions” on page 18.
QUICK CHART
Button Button Functions Button Options Buttons Button Functions
Button Options
Lock Doors & Arm System Press and Hold for 3
seconds
Activate “Panic” feature
Aux#3 Press Button #1 and #4 at
the same time
Unlock Doors & Disarm
System
Press twice for second door
unlock
Aux #4 Press Button #3 and #4 at
the same time
Trunk Release (Aux # 1) Press and Release for Aux
#1
Car Jack
(See page 14)
Press Button #1 and #3 at
the same time
Aux #2 Press and Hold button # 2 &
# 3 for 3 sec.
Silent Arm/Disarm
Press Button #2 and #4 at
the same time
Start or Stop engine
Press and Hold for 2
seconds
Press and Hold for 3 seconds
Press 5 times to Disable/Enable audible beep tones from the remote
2-car operation (Side Button)
(Change from Car 1 to Car
2) or Car 2 to Car 1
Press and Release to Recall the last message from the LCD screen
#1 ARM/
LOCK
#4 ENGINE
START/STOP
#5
RECALL /
CAR I OR II
#3 TRUNK
POP
#2 DISARM/
UNLOCK
ANTENNA
FIXED
LCD
SCREEN
PM