Filter
Top Products
14
ANTI CARJACK PROTECTION
REMOTE OPERATED CARJACK PROTECTION
This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is
running), press and hold the #1 LOCK Button and #3 TRUNK Button for 2 seconds. The parking lights will
flash 2 times and the LED will begin to flash rapidly to confirm the beginning of a Carjack countdown. 30
Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into a
full system activation with siren / flashing light pulses for up to 5 min. If the Ignition is turned off during a
Carjack trigger the siren and lights stop but Carjack protection is still active. The Siren and Lights will resume
if the Carjacker tries to turn the Ignition back ON. TO RESET: Press Button #2 (UNLOCK) on the remote and
the siren will chirp once, or turn the key on and press and hold the override button for at least 5 seconds.
SWITCH-CONTROLLED & FULL TIME CARJACK (PINK WIRE CONFIGURATION)
This feature can provide Passive or Manual control Carjack protection depending on the configuration of the
Pink Carjack wire of the alarm system. The system must be programmed for the Pink wire to be used as a
Carjack trigger with programming option #20. Once programmed for the Pink wire for use as a Carjack trigger,
it can be configured in different ways to provide different levels of protection. It can be connected to a hidden
+12V toggle/momentary switch or to +12V Ignition Power. Read following sections for further descriptions.
HIDDEN SWITCH-CONTROLLED CARJACK:
This configuration will enable the vehicle owner to activate a Carjack countdown by pressing a hidden push-
button (not included with kit) during a Carjack situation. A Carjack countdown will begin under the following
conditions: Ignition is ON (vehicle is running), the push-button is pressed, and the door opens/closes. Upon
these 3 events, in that order, the alarm will start a Carjack countdown. After a delay of one minute, the system
will begin chirping for 20 seconds then trigger into a full cycle for up to 5 minutes. To reset this Carjack mode,
Ignition must be ON then press and hold the override/valet button for 5 seconds (until LED goes out.)
FULL-TIME [Permanent] CARJACK:
We recommend that this configuration only be used if a serious threat of Carjack exists during everyday
situations. When the Ignition is on (vehicle is running), anytime a door is opened the Carjack countdown
sequence will be initiated. There will be 2 light flashes and the LED will change from solid to quick pulsing as
confirmation of a countdown sequence. To reset FULL TIME Carjack, the Ignition has to be ON, then press
and hold the override/program button 5 seconds until LED stops pulsing. The LED will be on SOLID when in
this mode anytime the Ignition is ON (or while driving) as a reminder that Carjack is waiting for a door to open.