Crimestopper Security Products CS-2016DP-FM Automobile Alarm User Manual


 
6
PM
SILENT ARM
PM
SILENT DISARM
PM
P
PANIC MODE
OPERATING INSTRUCTIONS - ALARM
Disarming While Tripped (Triggered):
Disarming the System while it is triggering requires TWO presses of the #2 Unlock Button. The first press of
Button #2 Resets the alarm cycle only (system still armed) while a second press will disarm/unlock the system.
Selective Silent Arming/Disarming:
To Arm or Disarm the system without siren
chirps, press and release both Buttons #2
(Unlock) and #4 (Start) at the same time.
System will Arm or Disarm without siren chirps.
Flashing lights and LED will be the only
indicators of Arm/Disarm status. The LCD will
Display a musical note with an X” when the
system is armed or disarmed without a chirp.
Prior intrusion Alert
This system will notify you if the alarm was tripped while you where away. Upon disarming, the two normal
disarm chirps will be heard then the system will emit 4 additional siren chirps. Check your vehicle for any
signs of a break in or tampering. Also see LED Diagnostics Section to determine the cause of the trigger.
Remote Panic Protection
To sound the alarm in an emergency situation or to draw attention to your vehicle, press
and hold Button #1 (Lock) for at least 3 seconds until the siren sounds. Press Button #2
(Unlock) to reset panic mode. The LCD pager/remote will display a P and emit 8
beeps when the panic mode is triggered.
Selective Shock Sensor Disable
To arm the alarm and bypass shock sensor protection, press Button #1 as normal then
press and release Button #1 and #2 together within 2 seconds. You will hear 3 extra
siren chirps indicating shock sensor bypass for this arming cycle only. This feature can be used when parking
near railroad tracks, airports, or area with excessive loud machinery or noise to prevent the nuisance of
unnecessary false alarms.
Open Door Alert / Bypass
Upon arming, this system will warn you if a door is left open. The LCD pager will vibrate and beep (15Xs)
along with displaying the open zone on your LCD screen. This zone will automatically be bypassed until
closed, otherwise the alarm will continue to protect all other zones.