Filter
Top Products
OPTION PROGRAMMING
CS-2003DC PROGRAMMABLE OPTIONS
1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear 6 confirmation chirps.
2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the feature list below. The siren will chirp for each button press. DO NOT LOSE COUNT!!
3. When you get to the desired option number, press buttons #1, #2, or #3 (Lock, Unlock, Trunk) on the transmitter to
change the option. Button 1 gives a single light flash, Button 2 gives two light flashes, and Button 3 gives three light
flashes. See chart Below for Option descriptions and vales.
4. Change ONE option at a time repeating steps 1-3 as needed. When you are finished customizing options, check
operation to see if the option(s) have changed.
PROGRAMMING OPTIONS CHART
Option #
Option Description BUTTON 1
LOCK
(Default)
BUTTON 2
UNLOCK
BUTTON 3
TRUNK
1. Passive Arming ON OFF
2. Quiet Chirp Arm/Disarm
with Button #3
ON OFF
3. Lights on with disarm ON OFF
4. Active Re-Arm ON OFF
5. Silent Arm/Disarm OFF ON
6. Disarm with trunk pop OFF ON
7. Ignition controlled Locks ON OFF
8. Door Lock Pulse Time 0.7 Sec. 3 Sec.
9. Carjack Enable/Disable DISABLE ENABLE
10. Lock with passive arm ON OFF
11. Double Unlock Pulse OFF ON
12. Type of Carjack Protection
ACTIVE PASSIVE FULL-TIME
13. 10/60 Sec. Door Open
Warning
10 Sec. 60 Sec.
14. Horn Chirps OFF Arm/Disarm
Only
Arm/Disarm/
Pre-Warning
1. PASSIVE ARMING
This option controls the Passive (Automatic) Arming feature. If ON, arming will occur 30 Seconds after the ignition is
turned off and the last door has been closed. The LED will begin flashing rapidly while counting down. If a door is
reopened, the system will wait (LED solid) for the door or zone to close before arming. The unit will chirp once and
flash the lights once. Doors will lock if passive locking is selected. Factory default setting is ON.