Filter
Top Products
5
WIRING
BLUE/WHITE WIRE: NOT USED
BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
Connect to RED siren wire from the Siren in the engine compartment.
WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT
Connect to the switched parking light wire at back of light switch. If this is not possible, connect directly to one
of the parking lights at the front of the vehicle. European vehicles require separate right and left circuits. Use
a dual relay or 2 diodes to separate the output signal.
RED WIRE: +12V POWER INPUT (15 amp fuse)
Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the
vehicle battery positive terminal.
WIRING: PROGRAM/OVERIDE SWITCH AND LED
PROGRAM/OVERRIDE SWITCH: 2 PIN PLUG (REQUIRED FOR PROGRAMMING & LEARNING
REMOTES)
This switch is used for programming features, transmitters, valet mode, and to override the optional starter
disable (if installed) in the event of a non-operating remote control.
LED: 2 PIN PLUG
The LED is used as a VALET/PROGRAMMING indicator and it will also FLASH for use as security deterrent
when Remotely Locking the door.
VALET / PROGRAM SWITCH
STATUS LED