Filter
Top Products
18
OPERATING INSTRUCTIONS
SELECTIVE SILENT ARM/DISARM THROUGH REMOTE CONTROL
This system can be armed and disarmed without siren chirps on an “as needed” basis. Press and release
Button #4 for arm/disarm without siren chirps.
PROGRAMMABLE SILENT ARM/DISARM MODE (CHIRP DEFEAT)
The system can be silently armed and disarmed as normal with Lock/Unlock Buttons, but no siren chirp. See
alarm programming option (#8) to enable or disable this feature.
EMERGENCY OVERRIDE / DISARM
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to
open the door with the key, which will activate the alarm. Turn the ignition on and press the override/program
button for about 5 seconds (until siren stops). The Alarm will disarm. If you continue to hold the button for
additional 7 seconds, the system will enter the Valet mode.
EMERGENCY DISARM WITH CUSTOM OVERRIDE
If you have programmed your system for Custom Override, follow the same steps above (Emergency
Override) while pressing the valet button 2-15 times as you have programmed. You must continue to hold the
button down on the last press for 5 seconds. The Alarm will disarm and enter the Valet mode, which allows
you to use the vehicle until you can repair/replace the remote transmitter or have the alarm system checked.
VALET MODE
To disable the Alarm system for vehicle service or otherwise, turn the ignition on and press the
override/program button 4-5 seconds until the dash LED turns on solid and you hear (1) siren chirp. Repeat
the process to exit VALET mode and the system will chirp (2) times and the LED will turn off. Lock/Unlock and
AUX features will still operate in when in VALET mode. When performing an Emergency Override and you
hold down the override button, the system is also placed into Valet mode. See Emergency Override section
on previous page.
PASSIVE ARMING / PASSIVE LOCK MODES / PASSIVE CHIRP COUNTDOWN
If programmed, passive (Automatic) Arming will occur 30 Seconds after the ignition is turned off and the last
door has been closed. The LED will begin flashing rapidly while counting down. If a door or hood is
reopened, the system will wait (LED off) for the door or zone to close before arming. The unit will flash the
lights once. Doors will lock if passive locking is selected. May qualify for insurance discounts-check with your
agent or proprietor. When the Unit is programmed for Passive Chirp Countdown, the siren will chirp during
passive countdown, as an audible warning that arming will occur. This siren will emit a chirp every 2 seconds
as soon as the last door is closed until the system arms 30 seconds later.