Filter
Top Products
pager is in range to receive commands, hold buttons for 2.5 seconds – if the pager
LEDs illuminate and beep, the pager is in range to receive commands.
Active Lock/Arm and Unlock/Disarm
Tap button for 0.5 seconds to lock/arm and unlock/disarm. The icon will flash on
your remote. If your vehicle is locked, tap button
to unlock; if your vehicle is unlocked, tap button
to lock.
IMPORTANT: If the alarm has been triggered (Siren is going off), you must wait until the remote pager
has been paged before disarming the alarm – the first button tap will shut off the alarm and the second
will unlock/disarm the system.
Passive Lock/Arm
The system can be configured to passively lock and arm the vehicle. Put the system in
passive by taping buttons
simultaneously for 0.5 seconds. The remote will
beep once and the
icons will illuminate to indicate the system is in passive lock
and arming mode.
While in passive mode, the system will lock and arm the alarm 30 seconds after the last door is closed.
As an indicator that the vehicle is going to passively lock and arm, the remote and siren will chirp once
and the parking lights will flash once at both 10 and 20 seconds prior to passively locking and arming. If
you want the system to passively arm and not passively lock, ask your local CompuStar dealer to turn
Option 1-8 to setting II.
Automatic Transmission Remote Start Function
Press button for 2.5 seconds to remote start an automatic transmission vehicle. If you are in range
and if the vehicle is ready to remote start, the remote will beep once and the
LED will light up to
indicate that the remote start command has been successfully transmitted.
If you are in range, the remote beeps three times and parking lights on the car flashes, there is a remote
start error. Refer to the “remote start error diagnostic” on the last page of this manual for details.
Upon receiving confirmation that your vehicle is running, all the LEDs will flash. The remote start run-time
can be programmed for 3, 15, 25, or 45 minutes - ask your local CompuStar dealer to adjust Option 2-7 if
you would like a run-time other than 15 minutes (default).
IMPORTANT: Your vehicle’s key must be inserted into the ignition and turned to the “on” position prior
to driving your vehicle. If the foot brake is depressed prior to the key being in the “on” position, the
vehicle will shut off.
Manual Transmission Remote Start Function (Reservation Mode)
In order to remote start a manual transmission vehicle, the system must first be set in Reservation Mode.
Reservation Mode must be set each and every time you want to remote start a manual transmission
vehicle. The purpose of Reservation Mode is to leave the transmission in neutral before exiting the
vehicle.
IMPORANT:
8