Filter
Top Products
outputs up accordingly. Using auxiliary outputs to control additional vehicle functions will require
additional parts and can be rather labor extensive.
Tap button
for 0.5 seconds to trigger auxiliary output 1. Tap button for 0.5 seconds to
trigger auxiliary output 2. The remote will beep once and the
or icon will illuminate indicating that
the auxiliary outputs have been triggered.
By default, the system is in secure auxiliary mode. When in range of your vehicle, the remote will display
upon holding buttons for 2.5 seconds. This is to activate Query Mode to
activate secure auxiliary on your system. To turn off secure auxiliary, ask your authorized CompuStar
dealer to turn on Option 4-5 to setting II.
Silent Arm/Disarm
Upon lock/arm and unlock/disarm, you can eliminate vehicle’s audible confirmation by muting
the siren. Normally, the siren will chirp once to indicate the system is locked/armed and twice
to indicate the system is unlocked/disarmed. To mute the siren tap buttons
simultaneously for 0.5 seconds. The icons will flash on your remote when you send this
command. When the siren is muted, it will still go off in the event the alarm is triggered.
Shock Sensor On/Off
Hold buttons simultaneously for 2.5 seconds to turn on and off the shock
sensor. The remote will beep and the
icons will flash to confirm the shock sensor is
off. The remote will beep and the
icons will flash to confirm the shock sensor is on also.
IMPORTANT: Turning off the shock sensor also turns off the optional sensor.
Adjusting the shock sensor sensitivity is done at the actual sensor, which is generally mounted
somewhere under the vehicle’s dashboard. The higher the number on the dial means greater sensitivity
to impact. The recommended dial setting for most vehicles is somewhere between 2 & 4. If you are
testing your sensor, please note that the shock sensor does not recognize impact for 30 seconds after
the system has been armed.
Advanced System Functions
The following section reviews advanced system functions. Many of these functions require multiple steps
or additional programming by your local authorized CompuStar dealer to be active.
Drive Lock/Ignition Controlled Door Locks
Tap buttons simultaneously for 0.5 seconds to turn on and off drive lock
(also known as ignition controlled door locks). The remote will beep once and the
icons will
illuminate to confirm that drive lock mode is activated.
IMPORTANT: Drive lock mode requires that the dealer turn on Option 1-9. Drive lock has two settings;
10