Filter
Top Products
Detection
Your Detector
Nothing Comes Close to a Cobra
®
25
Settings
Your Detector
24
English
Detection
•
Signals Detected
The tables on the following pages show you the types of Signals your
detector will detect, as well as the visual alerts it provides for each of them.
Audio Alerts
A distinctly different Alert tone is used for each type of signal detected
(including separate tones for each laser signal). For X, K, Ka and Ku band
radar signals, the tones will repeat faster as you approach the signal
source. The repeat rate of the tones gives you useful information about
the signal detected. See responding to alerts on page 29.
Visual Display
An indication of the type of signal detected will appear in the DigiView
Data Display. During X, K, Ka and Ku alerts, you will also see from one
to five vertical bars, indicating the strength of the signal detected.
Signal Strength Chart
Signal Strength = 1
(Weakest Signal)
-
Signal Strength = 2
-
-
-
Signal Strength = 3
-
-
- -
-
-
-
Signal Strength = 4
-
- -
- -
- - -
-
-
-
-
Signal Strength = 5
(Strongest Signal)
-
-
_
-
-
- - -
- - -
- - - -
-
-
-
-
_
1 2 3
4 5
Setting Dim Default
You can set the default level for Dim mode (Dim, Dimmer or Dark)
either in Program mode or directly using the Select/Dim button.
To Set the Display Dim Mode Default Directly Using the Set/Dim Button
Press and hold the
Select/Dim button.
Tone
Visual Display
One beep each time the
display cycles
Cycles – see chart above
Release the Select/
Dim button to select
the current display as
default.
None Dim, Dimmer or Dark
To Set the Display Dim Mode Default Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
go to Display Dim,
Dimmer or Dark.
Tone Visual Display
Two beeps Dim
One beep Dimmer
One beep Dark
Select/Dim
Button
Press
and hold
Select/Dim
button
Dim
Dark
Dimmer
XRS9670_MANL_A.indd 24-25 8/30/10 8:37 AM