Filter
Top Products
Your Detector
Comes Close to a Cobra
®
19
Settings
18
Pop Alert
The Pop Mode Radar Gun is a single-pulse Doppler radar that is a feature
of a K and Ka (Bee III Ka radar gun) band Instant-On radar gun. It uses
a single, short-time pulse to measure the target vehicle’s speed.
The Pop mode receiver senses Pop singles beyond the effective range of
Pop radar guns. As the Pop mode receiver is so sensitive, you should limit
the use of Pop Detect mode to highway and rural driving.
Pop Alert will alert you to Pop radar signals. During the alert, the unit
continues to detect other signals. The factory setting is Pop Detect Off.
To Turn Pop Detect Mode On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
go to Pop Detect.
Tone Visual Display
Two beeps Pop On
One beep Pop Off
K, Ku and X Band Detection
The new Ku Band may be introduced to North America in the future. To prevent
false alerts until it is, the factory default for Ku Band detection is Off. In parts of
North America, annoying false alerts from door openers and similar devices are
triggered on the X Band and K Band. If desired, X Band or K Band can be turned
Off. The factory default for X Band and K Band detection is On.
To Turn X, K and/or Ku Mode On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
go to X, K or Ku band.
Tone Visual Display
Two beeps X-Band On
One beep X-Band Off
Two beeps K-Band On
One beep K-Band Off
Two beeps
One beep
Ku-Band On
Ku-Band Off
Ku-Band On
Ku-Band On
Ku-Band Off
Ku-Band Off
X-Band Off
X-Band Off
K-Band On
K-Band On
K-Band Off
K-Band Off
Tone Visual Display
One beep Compass not set…
Please try again…
NOTE
If you do not press the Set/City button within two minutes after beginning
the set compass process, compass calibration will automatically terminate.
Compass n...
Please tr...
Terminate
Set Compa...
Set Compass
Drive in...
Press SET...
Calibrate Compass
Compass
Set!
Compass Set
NW h
To Calibrate the Compass Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to
Set Compass.
Tone
Visual Display
None Set Compass
Press and release the Set/City button
to begin setting the compass.
One beep Drive in 2 circles…
Press SET when
done…
Within two minutes, drive your
vehicle in a circle twice, then press
the Set/City button again.
Three beeps Compass Set!
For two seconds
followed by direction
of travel (N, NE, E,
SE, S, SW, W or NW)
Press and release either the Select/
Dim button to proceed to the next user
mode or the Program/Mute button
to exit Program mode.
None None
Pop Detect On
Pop On
Pop Detect Off
Pop Off
X-Band On
Settings
Program/Mute Button
Set/City
Button
Select/Dim
Button
XRS9670_MANL_A.indd 18-19 8/30/10 8:37 AM