Filter
Top Products
English
12
Settings
Your Detector
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Nothing Comes Close to a Cobra
®
13
Your Detector
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
IntelliMu...
Intelli...
Mute
Off
button ag...
desired RPMs
Intelli
Mute
Set!
Hold 2 IntelliMute Button
IntelliMute Not Set
Rev Level Set
To Set the IntelliMute Activation Point
Press and hold
the IntelliMute
button for two
seconds.
Tone Voice Visual Display
Two beeps Set Engine Revs Press IntelliMute
button again at
desired RPMs
Rev your engine to
the level you wish
to set (recommend
slightly above idle)
and hold revs steady
for two seconds.
None None None
At the desired
rev level, press
and release the
IntelliMute button.
Three beeps IntelliMute Set IntelliMute Set!
Tone Voice Visual Display
Four beeps IntelliMute Not
Set, Please Try
Again followed by
IntelliMute not set
Please try again
One Beep
IntelliMute Off IntelliMute Off
NOTE If the unit is unable to sense usable pulses
within three seconds or if you do not set a rev point
within 20 seconds of beginning these steps, IntelliMute
will indicate an error and automatically turn Off.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
IntelliMute Pro
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as VG-2,
Spectre I and Spectre IV when traveling at slower speeds. It is intended for use by
experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector’s radar detection circuits are turned Off to prevent
detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set the
IntelliMute activation point. (See pages 11 through 12.)
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
To Turn IntelliMute Pro On
While no signal
is being detected,
press and hold both
the IntelliMute and
City/Hwy buttons for
four seconds.
Tone Voice Visual Display
Two beeps IntelliMute Pro
On
i blinks continuously
in the display after
IntelliMute Pro On
blinks
To Turn IntelliMute Pro Off
Press and hold both
the IntelliMute and
City/Hwy buttons for
four seconds.
Tone Voice Visual Display
One beep IntelliMute Pro
Off
IntelliMute Pro Off
blinks in the display
IntelliMute Pro On
i h
NOTE
The arrow up or down will continue
to show that engine RPMs are above
or below the user-set value.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
IntelliMute Button
City/Hwy Button
Press and Hold 4 both
buttons simultaneously
IntelliMute Button
Press and release