User- selectable fea tures
Your Smart Remote Starter III system comes from the factory with all of its features
pre-programmed as noted in the following table. No programming is required, but if you
wish to change any of the settings, just use the procedure below. To restore the feature to
its factory setting, just repeat the procedure:
1. Select the feature you wish from the table. Note the number of momentary taps.
2. Turn your vehicle’s ignition switch to its “ON” position.
3. Enter your valet code as noted on page 10-11, then immediately tap and release
the momentary side of the switch the number of times corresponding to the
feature you wish to change. Beginning with the 4th tap, the LED will blink each
time you tap thereafter to help you count (e.g., 5 blinks for feature 8; 9 blinks for
feature 12, etc.).
a.If noted, perform the “Secondary action.”
b. If noted, wait for the “Completion confirmation.”
4. Turn the ignition off. Repeat steps 1-4 for any other feature you wish to program.
13
Feature
Factory
setting
# of
taps
Secondary action
Completion
confirmation
Result
Battery Mode
AutoStart
OFF 4 — 2 flashes=ON Change from OFF to ON
Temperature Mode
AutoStart
OFF 5 — 2 flashes=ON Change from OFF to ON
AutoUnLock ON 6 —
1 flash=OFF
2 flashes=ON
Change from OFF to ON
or vice-versa
AutoLock ON 7 —
1 flash=OFF
2 flashes=ON
Change from OFF to ON
or vice-versa
AutoActivation
of starter interrupt
ON 8 —
1 flash=OFF
2 flashes=ON
Change from OFF to ON
or vice-versa
AutoActivation
of door locks
OFF 9 —
1 flash=OFF
2 flashes=ON
Change from OFF to ON
or vice-versa
Feature 10 requires installer programming. Do not change the status of feature 10.
Set new valet code 2 11
See Setting your own secret valet code on page 11.
Add a
new remote control
— 12
Press button 1 on the
new remote control
2 flashes
New remote control has
been added
Features 13-14 require installer programming. Do not change the status of feature 13 or 14.
Set headlight duration ✱
30 sec. 15
After 15th tap, start
counting. Turn ignition off
after desired duration
—
New headlight duration
has been set
✱ WARNING: DO NOT change the headlight duration if the system automatically
closes the power windows every time you remotely lock the doors. Doing so may
damage your vehicle’s window/sunroof motors.