Filter
Top Products
Smart AutoTesting™
Each time you remotely arm the system, it tests all triggers and sensors. If the hood or
trunk is open when you remotely arm, the system will immediately alert you of the
problem by sounding 4 chirps and 4 parking light flashes instead of the usual 2 and 2.
If a door is ajar, you will receive the usual 2 chirps and flashes, then, 5 seconds later,
there will be 4 chirps and 4 flashes. (This door ajar warning will not work on vehicles
that have factory-delayed courtesy lights). If a sensor is malfunctioning, you will
receive the usual 2 chirps and 2 flashes, then, 10 seconds later, there will be 4 chirps
and 4 flashes.
NOTE: Since this is a warning indication, you will hear the 4 chirps even if you
have the chirp muting feature turned on.
Specific malfunction identification: The system can also indicate the specific
trigger or sensor that is malfunctioning. If you get the 4-chirp/4-flash signal upon
arming, perform the following to identify the malfunctioning trigger or sensor:
1. Remotely disarm, then turn on the ignition. The LED status indicator inside your
vehicle will be flashing, pause, then repeat.
2. Count the number of blinks in one cycle between pauses (for your convenience, the
blink cycle repeats a total of 5 times) and refer to the chart below:
Automatic malfunction bypass
To provide the utmost protection even if a system component malfunctions, the system
will automatically bypass any faulty point and arm all
other
triggers and sensors to
provide the utmost possible protection until you can have the system serviced by your
local Authorized Clifford Dealer. If you accidentally armed with the hood, trunk or a
door open, just close the open point and the system will again monitor that point.
Multiple-event TotalRecall™
The system’s memory records the identity of the last eight activated or malfunctioning
triggers and sensors, which allows your installer to instantly track down malfunctions. To
identify the triggers and sensors held in the system’s memory, use the following procedure:
1. With the ignition OFF, flick the PlainView valet switch to its latched side.
2. Press button 1 to “arm” the system, then again to “disarm.”
Number of LED blinks between pauses Sensor/trigger indication
1 blink Piezo Sensor
2 blinks Optional sensor
3 blinks* Door trigger*
4 blinks Trunk trigger
5 blinks Hood trigger
* If your vehicle has a factory-installed feature that turns off or dims the interior courtesy lights
several seconds after you exit the vehicle, the system cannot provide this indication.
17