Filter
Top Products
What each button/channel does
Your IntelliGuard 700-IQ remote controls come pre-programmed so that certain
channels command certain functions. If you wish, you can actually assign any channel
except 9 through 12 to any function (see pages 20-24). The following chart indicates what
each remote control channel number does, and how to transmit each channel number.
TO ARM
THE SYSTEM . . . . . . .
Press button 1 (channel 1) once. You will hear two chirps and the
parking lights will flash twice. The dashboard LED will flash
repeatedly and the car doors will automatically lock.*
TO DISARM
THE SYSTEM . . . . . . .
Press button 1 (channel 1) again. One chirp and one parking light
flash confirms disarming. In addition, the doors will automatically
unlock* and the interior lights will turn on and stay on for 30
seconds or until you start the engine, whichever occurs first.
TO SILENTLY
ARM OR DISARM
THE SYSTEM . . . . . . .
Press button 3 (channel 3). Your IntelliGuard 700-IQ system will
arm or disarm with all the indications noted above
except
for the
chirp acknowledgments.
* Some vehicles require optional relays and wiring.
Factory settings of the 12 remote control channels
Transmitting
channel
number:
Causes the system to:
Press the
LevelShift
button?
How
many
times?
Press
button
number
1 arm or disarm and lock or unlock the doors no — 1
2 pop the trunk* (if the system is disarmed) no — 2
3 silently arm or disarm no — 3
4 activate optional accessory function #1 no — 4
5 activate optional accessory function #2 yes once 1
6 activate optional accessory function #3 yes once 2
7 activate optional accessory function #4 yes once 3
8 activate optional accessory function #5 yes once 4
9 remotely enter or exit valet mode (see pages 14) yes twice 1
10 remotely override optional sensor #2 (see page 15) yes twice 2
11
remotely adjust sensitivity of the Piezo Sensor’s
primary zone (see page 15)
yes twice 3
12
remotely adjust sensitivity of the Piezo Sensor’s
warning zone (see page 15)
yes twice 4
10