Filter
Top Products
High-output MultiSound Medallion™ Siren
All the electronics for the siren are built into the IntelliGuard 700’s control unit rather
than the siren itself. This protects the circuitry from engine heat, dirt and exposure to the
elements (in contrast, the electronics of other alarm companies’ sirens are part of the
siren itself and, therefore, far more susceptible to failure). In addition to greatly enhancing
long-term reliability, your IntelliGuard 700 also provides these additional features:
Personalized Siren Sounds: Most alarm sirens have a single “warble” tone. A
few offer “six-tone” sirens that either cannot be adjusted or require the physical
destruction of certain circuit wires in order to change the sounds (the change is
permanent and cannot be changed again). Your IntelliGuard 700 MultiSound
Medallion Siren circuitry is different. As shipped from the factory, the siren
sounds six different alarm sound patterns. However, you may turn any of the six
different alarm sound patterns on or off to create a different combination of sound
patterns. In all, there are 64 different combinations you may select. You may set
your own Personalized Siren Sounds so if you hear a siren at a distance, you will
know for sure whether it is your car or someone else’s. See User-selectable
features
on pages 19–21.
QuietChirps™: You can control the volume of the normal arm and disarm chirps.
As shipped from the factory, your IntelliGuard 700 issues full-volume chirp
acknowledgments. If you prefer, you may reduce the chirp volume to a level that is
clearly audible, yet less obtrusive. See the User-selectable features section on
pages 19–21.
Long-term chirp silencing: Whenever you wish, you may choose to silence
your IntelliGuard 700 system’s arm and disarm chirps until you decide to restore
them. The parking light flashes will continue to provide visual confirmation of
remote controlled arming and disarming. See User-selectable features on pages
19–21.
Remote controlled chirp muting: Your IntelliGuard 700’s remote controlled
chirp muting capabilities are especially valuable when parking late at night in a
quiet residential area or any other time when you want to arm or disarm the
system silently. To arm or disarm silently, simply press button 3 (channel 3) on
your remote control instead of the usual button 1 (channel 1).
Siren duration: When the system detects an intrusion attempt, the alarm is set to
sound for 30 seconds, then automatically reset itself. However, if you prefer, you
may change the siren duration cycle to 60 seconds. See the
User-selectable
features section on pages 19–21.
17