Filter
Top Products
2233
©
2005 Directed Electronics—all rights reserved
To turn the rear defogger output ON:
1. Simultaneously press & release the + +
buttons on the remote control.
2. The lights will flash 3 times.
3. The rear defogger output will once again activate when
the vehicle is remote started.
NNOOTTEE::
If the remote start is on the lights will turn off then flash 3-times
before returning to their normal output and the defogger output will
activate as programmed.
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle
for short periods of time, but would like to leave the motor run-
ning and the climate controls on.
TToo ppeerrffoorrmm VVaalleett TTaakkee--OOvveerr::
1. Before turning off the engine, press and release on the
transmitter twice (or press and release the optional momen-
tary switch twice).
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. Once the vehicle has started, it will run for the pre-program-
med period of time (12, 24, or 60 minutes) or until a shut-
down input is triggered.
NNOOTTEE::
This feature will not work if the brake pedal is being pressed.
VVaalleett TTaakkee--OOvveerr