Filter
Top Products
AutoLock/AutoUnLock™
For your safety and that of your passengers, the vehicle doors will automatically
lock the instant you turn on the ignition to start the engine (see User-selectable
features on pages 15-16). When you turn the ignition off to shut down the engine,
the AutoUnLock feature automatically unlocks the doors.
Magnetic Resonance Sensor™
The Magnetic Resonance Sensor detects intrusion-related vibrations and impacts.
For an even greater level of security, consider adding the optional Glass Tampering
Sensor that detects any attempts to break any of the vehicle windows or the
Proximity Sensor that detects any movement within the passenger compartment
(highly recommended for convertibles and other soft-top vehicles).
Smart AutoTesting™
Each time you remotely arm your Bullet II, it automatically performs an extensive
test of all system triggers and sensors. If the hood or trunk is open when you
remotely arm, the system will immediately alert you of the problem by sounding 4
chirps and 4 parking light flashes instead of the usual 2 and 2 (simply disarm, shut
the hood or trunk and re-arm to reactivate monitoring of that trigger point). If a door
is ajar or if the sensor is malfunctioning, you will receive the usual 2 chirps and 2
flashes, then, 5 seconds later, there will be 4 chirps and 4 flashes. (The door ajar
warning will not work on vehicles that have factory-delayed courtesy lights).
NOTE: Since this is a warning indication, you will hear the 4 chirps even if you
have the chirp muting feature turned on.
Specific malfunction identification: The system can also indicate the specific
malfunctioning trigger or sensor. If you get the 4-chirp/4-flash signal upon
arming, perform the following to identify the malfunctioning trigger or sensor:
1. Remotely disarm, then turn on the ignition. The LED status indicator inside your
vehicle will be blinking, pause, then repeat.
2. Count the number of blinks in one cycle between pauses (for your convenience,
the blink cycle repeats a total of 5 times) and refer to the chart below:
* If your vehicle has a factory-installed feature that turns off or dims the interior courtesy lights
several seconds after you exit the vehicle, the system cannot provide this indication.
Number of LED blinks between pauses Trigger/sensor indication
1 blink
Magnetic Resonance Sensor
2 blinks*
Door trigger*
3 blinks
Hood or trunk trigger
12