Filter
Top Products
19
© 2011 Directed Electronics. All rights reserved.
Remote Control Configuration
Remote Programming
The Responder LE and 1-way companion remote controls have opera-
tions that can be configured to a user’s personal preferences. The fol-
lowing instruction will direct you through the available programming
options for both remotes.
Enter programming, press and hold the
button for 8 seconds, the
remote emits one long beep and the transmit LED turns on to indicate
the Main Menu is accessed.
Exit programming or go back to a previous menu, press and release
the
button. 1 short and 1 long beep is emitted for each step back
and when programming is exited the transmit LED turns off.
Remote Pairing
The following instruction will step you through the remote pairing op-
eration.
Prepare the vehicle system for pairing:
1. Open at least one of the vehicle’s doors.
2. Turn the key to the ON position.
3. Within 5 seconds press and release 1 time the Control button on
the Control Center.
4. Within 5 seconds, press and hold the Control button. The status
LED will flash one time and the siren will chirp once to confirm the
system is ready for remote pairing.
5. Release the Control button and proceed below.
Pairing will exit if:
s Step 7 below is not completed within 60 seconds
s The doors are closed