Filter
Top Products
15
©
2004 Directed Electronics, Inc.
QUICK REFERENCE GUIDE:
To lock using your remote
■ To arm the system press for one second. The doors will lock (if con-
nected). The LED will begin to flash. The Failsafe
®
Starter Kill will pre-
vent the vehicle’s starter from cranking if it has been installed. The ve-
hicle’s horn (if connected) will honk and the parking lights will flash
once to confirm arming of the system.
To unlock using your remote
■ To disarm the system press for one second. The doors will unlock (if
connected). The Failsafe
®
Starter Kill will
be deactivated and the vehicle’s horn (if connected) will honk twice and
the parking lights will flash twice.
Disabling the Failsafe
®
Starter Kill without a transmitter
■ Turn on the ignition. Press and release the Valet
®
switch within 10 sec-
onds. The LED will stop flashing and the vehicle should start. Be sure to
check with the installer for the location of the Valet
®
switch.
To enter or exit Valet
®
Mode
■ Turn the ignition to the "ON" position. Turn the ignition back off. Press
and release the Valet
®
switch within 10 seconds. The status LED will
light steadily if you have entered Valet
®
Mode. To exit Valet
®
Mode,
repeat the steps above. The LED will turn off when exiting Valet
®
Mode.
To activate Panic Mode
■ Press and hold for 1.5 seconds.
Location of Shutdown Switch______________________________
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
✂
✂