Filter
Top Products
9
©
2004 Directed Electronics, Inc.
Rapid Resume Logic
This Directed Electronics system will store its current state to non-
volatile memory. If power is lost and then reconnected the system
will recall the stored state from memory. This means if the unit is
in Valet
®
Mode and the battery is disconnected for any reason, such
as servicing the car, when the battery is reconnected the unit will
still be in Valet Mode. This applies to all states of the system
including arm, disarm, and Valet Mode.
Programming Options
Programming options control your system's normal, operational
set-up. Most options do not require additional parts, but some may
require additional installation labor. This system's programming
options are listed below, with the factory default settings in bold:
■ Passive Mode or Active Mode. In Passive Mode the Failsafe
®
Starter Kill will automatically activate 30 seconds after the
ignition has been turned off.
■ The horn honk confirmations for locking and unlocking can be
programmed on or off. In order for this feature to be pro-
grammed on, the horn must be connected to the system.