Clarion MS2000 Automobile Alarm User Manual


 
MS2000 Owner’s Manual - Page 9
To operate the Auxiliary Function with the system Disarmed, press Button 3 for three seconds.
This function will stay active for as long as Button 3 is held.
Trunk Disarm
If the Auxiliary Function is being used to remotely open your car’s trunk, your installer can program the
system to automatically disarm the alarm when the auxiliary function is pressed while the system is armed.
This will allow you to load or retrieve packages from the trunk without having to first disarm the alarm.
Remote Car Starter
When an optional Remote Car Starter is installed, the Remote Transmitter can remotely start and run
your vehicle to warm-up the engine, as well as activate the heating / air conditioning system.
Additional Remote Transmitters
Additional Remote Transmitters for your MS2000 are available from your Authorized Ungo dealer.
You can use this chart to quickly identify and interpret the MS2000’s siren and LED indications.
Status Indications
1 chirp arming normal arming
1 + 4 chirps arming door, hood, or trunk is open
Output When Status
No chirps arming Valet Mode is on
LED double flashes Valet Mode Starter Defeat Activated
2 chirps disarming normal disarming
3 chirps disarming Tamper Alert - system was triggered
1 LED flash after Tamper Alert door
2 LED flashes after Tamper Alert shock sensor
3 LED flashes after Tamper Alert hood or trunk
5 chirps while Armed Warn Away
Multiple chirps while Armed & Door Open System Triggered
(Passive Arming Entry Delay Warning)
Mulitple chirps 1 minute after disarming Automatic Rearming
(for 10 seconds)
LED flashing quickly ignition key off Passive Arming sequence started
Two chirps ignition key off Full Time System Diagnostics
1 LED flash after Full Time Sys. Diag. door
2 LED flashes after Full Time Sys. Diag. shock sensor
3 LED flashes after Full Time Sys. Diag. hood or trunk
4 chirps with ignition key on Sensor Test mode on
1 chirp in Sensor Test mode impact detected