Filter
Top Products
Page 7SKU 38391
For technical questions, please call 1-800-444-3353.
To charge and recharge using the Power Cord and AC Inlet:
1. Insert the Power Cord’s female plug into the rectangular AC Input on the side
of the unit, and the male plug into a 120 VAC outlet.
2. For the initial charge, allow the Jump Start System to charge for 24
hours. For recharges, allow the Jump Start System to recharge for 8
to 10 hours. Check the recharge progress by pressing the red Button (15).
This will show the level of battery power on the Volt Meter (17).
3. This Jumpstarter System is equipped with an automatic cut off to help
prevent overcharging.
To recharge using a 12 VDC supply:
1. Insert the Cigarette Lighter Recharger Plug into the Front Panel port labeled
Recharge.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE
IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
REV 02/00; REV 04/06
Part Description Qty Part Description Qty
1 Case 1 19 Cigarette Lighter Cap 1
2 Light Case 1 20 Battery 1
3 Light Glass 1 21 Overcharging Cutoff 1
4 Light Cup 1 24 Screw M2.5 x 6 2
5 Cover 1 25 Screw M2.5 x 12F 2