Filter
Top Products
Black plate (32,1)
Chevrolet Impala Owner Manual - 2011
10-32 Vehicle Care
Taillamps, Turn Signal,
Sidemarker, Stoplamps,
and Back-Up Lamps
A. Rear Sidemarker Lamp
B. Back-up Lamp
C. Stoplamp/Taillamp/Turn Signal
To replace one of these bulbs:
1. Open the trunk. See Trunk on
page 2‑10.
2. Remove the convenience net
(if equipped). Unhook the net
from the upper wing nut.
3. Turn the upper wing nut
counterclockwise and remove it.
4. Pull the carpet away from the
rear of the vehicle.
5. Turn the two hex nuts
counterclockwise to
remove them.
6. Pull out the taillamp assembly
and disconnect the wiring
harness.
7. Turn the bulb socket
counterclockwise to remove it.
8. Pull the old bulb straight out to
remove it.
9. Push the new bulb straight in
until it clicks to install it.
10. Reverse steps 1 through 7 to
reinstall.