Filter
Top Products
Black plate (10,1)
Chevrolet Tahoe/Suburban Owner Manual - 2010
Reducing Speed While Using Cruise
Control
If the cruise control system is already activated,
.
Press and hold the SET– button on the steering
wheel until the desired lower speed is reached,
then release it.
.
To slow down in small amounts, press the
SET– button on the steering wheel briefly. Each
time this is done, the vehicle goes about 1.6 km/h
(1 mph) slower.
Passing Another Vehicle While Using
Cruise Control
Use the accelerator pedal to increase the vehicle
speed. When you take your foot off the pedal, the
vehicle will slow down to the previous set cruise speed.
Using Cruise Control on Hills
How well the cruise control will work on hills depends
upon the vehicle speed, load, and the steepness of the
hills. When going up steep hills, you might have to step
on the accelerator pedal to maintain the vehicle speed.
When going downhill, you might have to brake or shift
to a lower gear to keep the vehicle speed down. When
the brakes are applied the cruise control turns off.
Ending Cruise Control
There are three ways to end cruise control:
.
To disengage cruise control; step lightly on the
brake pedal.
.
Press [ on the steering wheel.
.
To turn off the cruise control, press I on the
steering wheel.
Erasing Speed Memory
The cruise control set speed is erased from memory by
pressing the
I button or if the ignition is turned off.
Exterior Lamps
The exterior lamps control
is located on the
instrument panel to the
left of the steering wheel.
It controls the following systems:
.
Headlamps
.
Taillamps
4-10