Filter
Top Products
Express-Up Window
On windows with this feature, pull the switch up to the
second position and release the switch to activate the
express-up feature. To stop the window as it is going
up, pull up or press down briefly on the switch again.
Programming the Power Windows
If the battery on the vehicle has been recharged,
disconnected, or is not working, the driver power
window will need to be re-programmed for the
express-up feature to work. Replace or recharge the
vehicle's battery before reprogramming.
To program the driver window, follow these steps:
1. With the ignition in ACC/ACCESSORY, ON/RUN,
or when Retained Accessory Power (RAP) is
active, close all doors.
2. Press and hold the power window switch until the
window is fully open.
3. Pull the power window switch up until the window
is fully closed.
4. Continue holding the switch up for approximately
two seconds after the window is completely closed.
The window is now reprogrammed.
Express Window Anti-Pinch Feature
If any object is in the path of the window when the
express‐up is active, the window stops at the
obstruction and auto‐reverse to a preset factory
position. Weather conditions such as severe icing may
also cause the window to auto‐reverse. The window
returns to normal operation once the obstruction or
condition is removed.
Express Window Anti‐Pinch Override
{
WARNING:
If express override is activated, the window will
not reverse automatically. You or others could be
injured and the window could be damaged. Before
you use express override, make sure that all
people and obstructions are clear of the
window path.
In an emergency, the anti‐pinch feature can be
overridden in a supervised mode. Hold the window
switch all the way up to the second position. The
window rises for as long as the switch is held. Once the
switch is released, the express mode is re‐activated.
In this mode, the window can still close on an object in
its path. Use care when using the override mode.
3-16