Filter
Top Products
If you set off the alarm by accident, turn off the alarm by
pressing unlock on the remote keyless entry transmitter
or by placing the key in the ignition and turning it
to START.
Testing the Alarm
The alarm can be tested by following these steps:
1. From inside the vehicle, activate the system by
locking the doors with the remote keyless entry
transmitter.
2. Wait for the security light to go out.
3. Unlock the door with the manual door lock and
open the door. This should set off the alarm.
4. Turn off the alarm by pressing unlock on the remote
keyless entry transmitter or by placing the key in
the ignition and turning it to START.
If the alarm does not sound when it should, but the
vehicle’s headlamps flash, check to see if the horn
works. The horn fuse may be blown. To replace the
fuse, see Instrument Panel Fuse Block on page 5-124
and Underhood Fuse Block on page 5-127.
If the alarm does not sound or the vehicle’s headlamps
do not flash, see your dealer for service.
Passlock
®
Your vehicle is equipped with the Passlock
®
theft-deterrent system.
Passlock
®
is a passive theft-deterrent system.
Passlock
®
enables fuel if the ignition lock cylinder is
turned with a valid key. If a correct key is not used or the
ignition lock cylinder is tampered with, fuel is disabled.
If the engine stalls and the security light flashes,
wait until the light stops flashing before trying to restart
the engine. Remember to release the key from
START as soon as the engine starts.
If the engine is running and the security light comes on,
you will be able to restart the engine if you turn the
engine off. However, your Passlock
®
system is
not working properly and must be serviced by your
dealer. Your vehicle is not protected by Passlock
®
at this
time. You may also want to check the fuse. See
Fuses and Circuit Breakers on page 5-124. See your
dealer for service.
In an emergency, call the GM Roadside Assistance
Center. See Roadside Assistance Program on page 7-6.
2-19