Filter
Top Products
2-72
To increase the space in the convenience system, do the
following:
1. Remove the individual partitions (C) by pulling
upward on the partitions. Storage for the partitions is
located in area (F).
2. Fold the collapsible dividers (A) by pulling upward
and folding the dividers toward each other.
To reinstall or rearrange the partitions, push down gently
on the partitions making sure both sides fit into the
appropriate slots of the collapsible dividers (A).
Located on the top of each collapsible divider (A) are
T
-pins designed to hold grocery bags, etc., in an
upright position.
The anchor bracket/cargo tie down plugs (B), located in
the center and on each side of the convenience system
nearest the passenger compartment, are used to help seal
the convenience system. However, the plugs also cover
the anchor bracket /cargo tie
-downs. To remove the
plugs, grasp the edges of the plugs and pull straight out.
See “Child Restraints” and “Top Strap” in the Index
for more information on using anchor brackets.
There are two cutouts (E) for the rear cargo tie
-downs
located near the endgate sill. In order to access the rear
cargo tie-downs, the cutouts must be removed.
You will also find a soda pop/gallon jug holder (D) on
the passenger side of the convenience system. Some
vehicles do not have this feature, but instead include a
smaller storage area.
To remove the entire convenience system, do the
following:
1. Remove the convenience net if it is in place. See
“Convenience Net” in the Index for more
information. You may also want to remove the
partitions (C) and fold the collapsible dividers (A) to
make the convenience system easier to handle.
2. Grasp the sides of the convenience system and push
the sides together while sliding the unit out until it
clears the sides of the endgate opening.
To reinstall the convenience system, reverse the removal
procedure.