Black plate (43,1)
Cadillac SRX Owner Manual - 2011
Vehicle Care 10-43
Back-Up Lamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
(Manual) on page 2‑14 or
Liftgate (Power) on page 2‑15.
A. Push Pin
B. Taillamp Cover
2. Pull on push pin (A) to release
the taillamp cover (B).
3. Remove the taillamp cover from
the lamp assembly by pulling
rearward from the top to
unfasten from snap tabs.
4. Remove the two screws from the
taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
A. Turn Signal Lamp
B. Back–Up Bulb/Socket
6. Disconnect the wire harness
from the back–up bulb/
socket (B).
7. Turn the back–up bulb socket
counterclockwise to remove it
from the taillamp assembly.