Filter
Top Products
Remote Vehicle Start✦
During a remote start, the automatic climate control system will
default to a heating or cooling mode, depending on the outside
temperature, until the ignition is turned on. Once the ignition is in
the On position, the automatic climate control system will operate
at the same setting as when the vehicle was last turned off.
Starting the Vehicle
1. Aim the keyless entry transmitter at the vehicle. (Transmitter
range depends on operating conditions.)
2. Press and release the Lock button on the transmitter.
3. Immediately press and hold the Remote Start button for at
least two seconds. When the vehicle starts, the parking lamps
will light and remain on while the engine is running. The
engine will continue running for 10 minutes.
4. Repeat these steps for a 10-minute time extension. Remote
start can be extended only once.
After a remote start, press the brake pedal and then press the
START/STOP button to turn on the ignition before driving.
Only two remote starts are allowed between ignition cycles.
Canceling a Remote Start
• Press and hold the Remote Start button until the parking
lamps turn off.
Note: Several conditions will cause the Remote Start feature not to
operate, see your Owner Manual for more information.
See Keys, Doors and Windows in your Owner Manual.
Keyless Start
Start
• With the vehicle in Park or Neutral,
press the brake pedal and then press
the START/STOP button to start the
engine. The green indicator on the button
will illuminate.
Note: The transmitter must be in the vehicle to turn on the ignition. If the
transmitter battery is weak, place the transmitter in the depression below
the Accessory Power Outlet in the center console lower storage area to
enable the engine to start.
Cell phone chargers may interfere with the operation of the
Keyless Start System and should not be plugged in when starting
or turning off the engine.
Stop
• Shift to Park and press the START/STOP button to turn off
the engine.
Power will be available for 10 minutes to operate the audio
system until the driver’s door is opened and to operate the
windows and sunroof✦ until any door is opened.
Accessory
• With the engine off and the brake pedal NOT depressed,
press the START/STOP button to place the ignition system in
the Accessory position. The yellow indicator on the button will
illuminate.
• Press the button again to return to the Off position.
Note: The battery may drain and the vehicle may not start if the ignition
is in the Accessory position for an extended period of time.
See Keys, Doors and Windows in your Owner Manual.
5