Bush Hog TH4200 Automobile User Manual


 
Vehicle Immersion
If it is impossible to take your vehicle to a dealer before starting it, fol-
low the steps outlined below.
Honda Engines
1. Move the vehicle to dry ground, or at least to a water level below
the floor.
2. Disconnect the fuel pump wires.
3. Remove the spark plugs.
4. Loosen the carburetor drain screw by turning the screw counter-
clockwise to allow fuel to drain from the fuel bowl . This screw is
accessible with a long handled screwdriver from above, and
behind the engine.
5. Turn the engine over several times with the electric starter.
6. Dry the spark plugs and reinstall, or install new spark plugs.
7. Tighten the carburetor drain screw.
8. Connect the fuel pump wires.
9. Attempt to start the engine. If necessary, repeat the drying pro-
cedure.
Briggs & Stratton Engines
The procedure for the Briggs & Stratton engine would be the same as
for the Honda except that there is no drain feature on the carburetor
fuel bowl. The carburetor should be removed and thoroughly cleaned
inside and out.
NOTE: Water damage to electrical components may necessitate
replacement of that component.
CAUTION
IF YOUR VEHICLE BECOMES IMMERSED, MAJOR
ENGINE DAMAGE CAN RESULT IF THE VEHICLE IS NOT
THOROUGHLY INSPECTED. TAKE THE VEHICLE TO
YOUR DEALER BEFORE STARTING THE ENGINE.
56