Filter
Top Products
Page 28
Restraint Belt Angles
Locate wheelchair in forward-facing position center-
ing wheelchair squarely within “L” track. The front
and rear belts, when attached, should create angles
approximately as shown in Figure 2. Preferred
angles and locations of belts from wheelchair se-
curement points to vehicle anchor points are shown.
Front tie-downs should be angled out far for lateral
stability when possible. Note: These are optimum
angles and cannot be achieved in some cases.
Keeper Fitting and “L” Track Attachment
Instructions
The belts supplied in the Forward-Facing Wheelchair
and Occupant Belt/Track System are equipped with
keeper fittings (attachments) which engage the “L”
track. Engage and release the keeper fittings as de-
tailed and shown on the following page. Note: Refer
to pages 32 and 33 for belt attachment and release
procedures.
WHEELCHAIR AND OCCUPANT RESTRAINT
Figure 2
Front View
Wheelchair Reference Plane
Rear
Securement
Points
Front
Securement
Points
12"
12"
45°
Side View
Side ViewRear View
30°
10°10°
40°
60°
25° 25°