BMW AG Automobile User Manual


 
18
Telltale and warning lights
Technical equipment that
monitors itself
The function of telltale and warning
lights marked
is checked when the
ignition is switched on. They light up
just once, but for different lengths of
time.
If a defect occurs in one of the systems,
the corresponding light will remain on
when the engine is started or will come
on again during the journey. The correct
response to this on your part is
described below.
Red: stop immediately
Battery charge current
The battery is not charging.
There is a defect at the V-belt
for the alternator or in the alternator's
charging circuit. Have the system
checked.
If the V-belt is defective, do not
continue the journey, otherwise
the engine may overheat and be dam-
aged. A defective V-belt also means
more effort than usual is required to
turn the steering wheel.
<
Engine oil pressure
The engine oil pressure is too
low. Stop immediately and
switch off the engine. Do not continue
your journey. Have the system
checked.
Do not continue the journey, as
the engine may otherwise be
damaged by inadequate lubrication.
<
Brake warning light
Comes on even though the
handbrake has been released:
check brake fluid level. Before resum-
ing your journey, be sure to comply with
the instructions on page 131. Have the
system checked without delay.
Runflat Indicator
In addition a warning signal is
heard: flat tyre. Reduce speed
and carefully bring the car to a stand-
still. Avoid abrupt braking and steering
manoeuvres.
For more information, see page 85.
Red and yellow: drive on, but
exercise restraint
If the brake warning light comes
on together with the yellow tell-
tale lights for ABS
and DSC:
The complete regulating sys-
tem for ABS, CBC, DSC and
ADB-X/DBC has failed. Drive
with care, looking at the traffic
situation well ahead, and avoid
heavy brake applications. Have the sys-
tem checked as soon as possible.
For more information, see page 79 ff.
Red: as an important reminder
Brake warning light
The light is on while the hand-
brake is applied – an acoustic
signal sounds if the handbrake is not
released before you pull away. For
more information, see page 59.
Fasten seat belts
Comes on for several seconds
or until the seat belt is fastened.
Depending on version, accompanied by
an acoustic signal.
For more information on seat belts, see
page 45.
Online Edition for Part-No. 01 41 0 158 017 - © 03/04 BMW AG