Filter
Top Products
109
Entertainment OverviewControlsDriving hintsNavigationMobilityReference
Practical interior equipment
Integrated universal remote
control*
Principle
The integrated universal remote control
replaces up to three different hand-held trans-
mitters for various systems or devices that are
operated by radio remote control, for example a
gate opener and domestic alarm systems. The
integrated universal remote control identifies
and learns the signals transmitted by the origi-
nal hand-held transmitters.
The signal from an original hand-held transmit-
ter can be programmed to one of the three
memory buttons 1. The system in question can
then be operated with the memory button 1
programmed in this way with the ignition
switched on. Transmission of the signal is
shown by the LED 2.
If and when you decide to sell your car, in the
interests of security clear the programmed
functions first, see page 110.
During the programming operation and
before a programmed system is operated
with the integrated universal remote control,
make sure that no persons, animals or objects
are within the pivoting or movement range of
the system in question, otherwise there is a risk
of injury or damage. Comply also with the safety
instructions supplied with the original hand-
held transmitter.<
Checking compatibility
If this symbol appears on the pack or in
the instructions supplied with the origi-
nal hand-held transmitter, you can
assume that the radio remote control device will
be compatible with the integrated universal
remote control.
A list of compatible hand-held transmitters is
available from the fax polling number
+49 (0)6838 907 283 3333. If you would like
more details, please call the freephone
Homelink hotline at +49 (0)6838 907 277, or
0800 0466 35465 from within Germany.
HomeLink is a registered trademark of Johnson
Controls, Inc.
Programming
1 Memory buttons
2 LED
Fixed-code hand-held transmitter
1. Switch on the ignition, see page 56.
2. When using for the first time: press the two
outer memory buttons 1 for approx. 20 sec-
onds, until the LED 2 flashes. All memo-
rised programs are deleted.
3. Point the original hand-held transmitter at
memory buttons 1 at a distance of approx.
5to20cm, approx. 2 to 8 in.
The required distance between the
hand-held transmitter and memory
buttons 1 depends on the system accord-
ing to which the original hand-held trans-
mitter operates.<
4. Press the command button on the original
hand-held transmitter and the desired
memory button 1 on the integrated univer-
sal remote control at the same time. The
LED 2 initially flashes slowly. When the
LED 2 starts to flash rapidly, release both
buttons. If the LED 2 does not start to flash
rapidly after approx. 15 seconds, change
the distance.
Online Edition for Part-No. 01 41 0 159 725 © 09/05 BMW AG