Filter
Top Products
Controls
69
Reference At a glanceDriving tipsCommunication NavigationEntertainmentMobility
Recalling stored messages
Using CHECK button
1. Hold the button down:
The first stored message is displayed.
2. Press the button:
When the button is pressed again, a differ-
ent message is displayed.
Using Control Center
Control Center, for principle details, refer to
page 16.
1. Press button.
This opens the start menu.
2. Press the controller to open the menu.
3. Select "Service" and press the controller.
4. Select "Check Control messages" and
press the controller. The stored messages
appear on the display
5. Select a message and press the controller.
The display disappears automatically after a
short time.
In order to exit from the display immediately:
Select the arrow and press the controller.
Displays after completion of trip
Malfunction reports generated during the trip
are shown consecutively when you switch off
the ignition.
Before the display disappears, you can display
the messages once again. Press the CHECK
button for approx. 2 seconds. If several mes-
sages are present, you can continue to press
the CHECK button to view them in succession.
The display goes out
> automatically after a brief period
> when you press the CHECK button again
for approximately 2 seconds.
Computer
Requesting functions
As of ignition key position 1, you can use the BC
button in the turn signal lever to call up com-
puter information in the instrument cluster.
Online Edition for Part-No. 01 41 0 158 518 - © 09/04 BMW AG