Filter
Top Products
Quick Reference Card
1
Programming Details ̈
Factory Default Settings
To reset your V955 to its original factory
settings, press and hold the “CITY” and
“BRT” buttons while turning the power
on. The V955’s display will provide a
“Reset” message, accompanied by an
audible alert, acknowledging the reset.
BEL V955 Quick Reference Card
̄ Remove card along perforations ̄
̄ Remove card along perforations ̄
An example
Here is how you would turn the V955’s
AutoMute feature off.
1 Enter the Program Mode by holding
both the CITY and BRT buttons down for 2
seconds. The V955 will beep twice and
display Program.
2 Then hold the RVW button down. V955
will scroll through the categories, starting
with Display (Pilot), then Voice(Voice),
then Power-On sequence (PwrOn), and
then AutoMute (aMute).
3 Release the RVW button when the V955
shows the AutoMute item. Since the
factory setting is for AutoMute to be on,
the V955 will display aMute ON.
(If you accidentally don’t release the
Review button in time, and the V955 goes
to the next category, hold the RVW button
down again, and after the V955 scrolls
through all categories, it will begin again
at the top of the list.)
4 Press the CHG button to change from
aMute ONto aMute OFF.
5 To complete the Programming, simply
wait 8 seconds without pressing any button.
The V955 will display Complete, beep 4
times, and return to normal operation.
There are 6 user-selectable options so you
can customize your V955 for your own
preferences.
The buttons labeled CITY and BRT are
also used to enter the Program Mode,
REVIEW your current program settings, and
to CHANGE any settings as desired. The
words PROGRAM, RVW and CHG are
located on the top of the detector, and are
highlighted in graphics.
How to use Programming
1To enter Program Mode, press and
hold both CITY and BRT buttons down
for 2 seconds. (The unit will beep twice,
and will display the word “Program”).
2Then press the RVW button to review
the current settings. (You can either tap
the button to change from item to item, or
hold the button to scroll through the items).
3Press the CHG button to change any
setting. (You can either tap the button to
change from setting to setting, or hold the
button to scroll through all the options).
4To leave Program Mode, simply wait
8 seconds without pressing any button.
(The unit will display Complete, beep, and
return to normal operation).