Beltronics V960/V940 Radar Detector User Manual


 
1. Consider occupant safety when selecting a mounting
location. Choose a location where the unit will not be
hazardous in case of an accident.
2. For optimum detection, position your unit with a clear,
unobstructed view of the road from the front and rear.
3. Do not allow the unit to make contact with the
windshield. This will eliminate unnecessary vibration.
4. Avoid placing your unit in direct sunlight. During the
summer, interior temperatures of an enclosed vehicle
can sometimes reach temperatures that will cause
premature aging of the unit.
5. Your detector is not waterproof; exposure to water may
cause damage and your warranty will be void.
Dash Mounting
You can mount your unit to a level area of your
vehicle’s dash using the hook and loop fastener or the
four, non-skid dash mounting pads provided.
Windshield Mounting
1. Remove the mounting cover on the top of the
detector by pressing on the raised dots and pushing
outward.
2. Insert the “grooved” cover plate supplied until it locks
into place.
3. Clean the desired area of the windshield, and adhere
the windshield/visor bracket by pressing on the suction
cups.
4. Slide the detector onto the mounting bracket until it
“locks” into place.
15
k
k