Beltronics RX65 Radar Detector User Manual


 
Controls and Features
10
Power Connector
RX65’s power jack uses a telephone-type
connector. This new 6-pin connector only
works with the included coiled SmartPlug,
or the optional Direct-wire SmartPlug.
The coiled SmartPlug is a special power
cord that has a power-on indicator (which
only lights up when the RX65 is turned on),
a bright alert light that warns of radar or
laser, and a convenient mute button right
on the plug. It’s perfect for any car where
reaching the detector’s mute button on the
windshield is a stretch.
For discreet night driving, put RX65 in
the Dark mode, and use the SmartPlug for
your visual alerts. Other drivers won't know
you have a detector.
An optional Direct-wire SmartPlug is
also available. This version includes a small
display module, which can be wired
directly into your electrical system, with a
10 foot straight cord to route to your RX65.
For more information or to order, call
us toll-free at 1-800-341-2288.
Signal Strength Meter
RX65’s alphanumeric display consists of
280 individual LEDs, to provide an intuitive
ultra-bright display of signal strength and
text messages.
RX65’s standard bar-graph signal
strength meter only displays information on
a single radar signal. If there are multiple
signals present, RX65’s internal computer
determines which is the most important
threat to show on the bar-graph meter.
When RX65 detects radar, it displays
the band (X, K, or Ka), and a precise bar
graph of the signal strength. When RX65
detects a laser signal, the display will show
“Laser.”
NOTE: If you are operating RX65 in the
Dark mode, the display will not light when
a signal is detected – only the audio alert
will be heard, and the flashing alert lamp on
the SmartPlug.
11
Threat Display
RX65’s Threat Display option is an
advanced display for experienced detector
users. Please use RX65 for a few weeks to
get familiar with its other features before
using Threat Display.
To use the Threat Display instead of
the bar graph signal strength meter, you
must select Threat Display in RX65’s
Programming (see pages 12-15).
RX65’s Threat Display simultaneously
tracks multiple radar signals and their
relative signal strength.
Threat Display can help you spot a
change in your normal driving environment;
for example, a traffic radar unit being
operated in an area where there are
normally other signals present.
The Threat Display is actually a
miniature spectrum analyzer. It shows what
band each signal is and its signal strength.
Ka9 K2 X1
Above is the Threat Display if the
RX65 was detecting a strong Ka-band, a
weak K-band, and a weak X-band signal.
NOTE: If you use Threat Display, the
brief signal shown in the power-on
sequence when you turn on your RX65 will
also be in Threat Display: an X with a
decaying numeric signal.
A few more examples will help you
better see how the Threat Display works.
K9 X1
Here Threat Display shows a strong
K-band signal, and a weak X-band signal.
Ka1 X9
Here Threat Display shows a weak
Ka-band signal, and a strong X-band
signal.
Threat Display Details
The band designators (X, K, Ka) will
stay on the display for a few seconds after
the signal has passed. This allows you to see
what the unit detected, even on very brief
signals.
Tech Display
BEL RX65’s new Tech Display option is also
for the experienced detector user. In this
mode, RX65 will display the actual numeric
frequency of the radar signal being
received.
K 24.150
Tech Display shows one K-band signal
at 24.150 gigahertz.
Note: Even long-time detector users
will require a significant amount of time to
get familiar with this new level of
information about detected signals.