Filter
Top Products
Troubleshooting
24
Problem
RX65 beeps briefly at the same
location every day, but no radar
source is in sight.
RX65 does not seem sensitive to
radar or laser.
RX65 did not alert when a police
car was in view.
RX65 did not provide a Safety signal
while within range of an emergency
vehicle.
RX65’s display is not working.
RX65’s audible alerts are less loud
after the first few alerts.
RX65 bounces or sags on wind-
shield.
RX65’s power-on sequence
reoccurs while you are driving.
Your 14-year old son has changed all
7 of the Programming options.
Solution
• An X-band motion sensor or intrusion alarm is located within
range of your route. With time, you will learn predictable
patterns of these signals.
• Make sure that windshield wipers do not block RX65’s radar
antenna and that the laser lens is not behind tinted areas.
• Determine if your vehicle has an Instaclear
®
, ElectriClear
®
or
solar reflective windshield which may deflect radar or laser
signals.
• RX65 may be in City Mode.
• VASCAR (Visual Average Speed Computer and Recorder) a
stopwatch method of speed detection, may be in use.
• Officer may not have radar or laser unit turned on.
• Safety transmitters may not be commonly used in your area.
• Press the BRT button to deactivate Dark Mode.
• RX65 is in AutoMute Mode. See page 8 for details.
• RX65 is not making contact with the windshield to provide
stability. While holding down RX65’s QuickMount button,
slide RX65 toward the windshield so that the back top edge
makes firm contact.
• A loose power connection or dirty lighter socket can cause
RX65 to be briefly disconnected.
You can return all of the programming options to the factory
defaults by holding down the CITY and BRT buttons while
you turn RX65 on.
25
Problem
RX65 will not turn on.
RX65 feels very warm.
Solution
• Check that the power is ON.
• Check that vehicle ignition is ON.
• Check that vehicle lighter socket is functional.
• Try RX65 in another vehicle.
• It is normal for RX65 to feel warm.
Explanation of Displays
AD Sensitivity control is in Auto mode, display is in Dark mode (page 9)
HD Sensitivity control is in Highway mode, display is in Dark mode (page 9)
CD Sensitivity control is in City mode, display is in Dark mode (page 9)
No display RX65 is in the Dark mode, and is programmed for Dark All (page 9,16)
PilotHWY One of the many programming messages (pages 12-16)
WorkZone One of the many Safety Radar messages (pages 22-23)
Caution RX65 has detected a Safety Radar Signal, but the signal isn’t yet strong
enough to decode the specific safety message (page 22-23)
X5, or K5, RX65 has been programmed in the Threat Display mode (page10-11)
or KA9 etc.
VG2 RX65 has detected a VG2 unit (radar detector detector)