Filter
Top Products
2. Turn on the ignition and press volume up on the RFASWC. This will
“marry“ the RFASWC to the interface.
NOTE: If you are replacing a transmitter you must turn on the ignition
and within the rst 10 seconds press and hold the source button for ten
seconds. This will “marry the new transmitter.
Programming the RFASWC
1. Complete connections to the vehicle and the aftermarket radio
* If this is the rst time the RFASWC is being installed in a vehicle:
2. Turn the ignition on; the led will start ashing rapidly which means the
ASWC is looking for the radio. Go to step 4.
Or
* If the RFASWC was installed in a vehicle before:
2. Turn the ignition on, the led will ash slowly
3. Hold down the reset button for more then 2 seconds but less then 10
seconds, the led will start ashing rapidly
4. After a couple of seconds the led should stop ashing and not light up
for 2 seconds.
3