Filter
Top Products
4. If you have a different radio then Eclipse, press the Volume Up button
again till the led goes solid red, then release Volume Up. You have
now programmed Kenwood.
5. Here is the chart to show how many presses of the Volume Up button
is needed for which radio you are trying to program:
1st led ash is for Eclipse
2nd led ash is for Kenwood
3rd led ash is for Clarion
4th led ash is for Sony and Dual
5th led ash is for JVC
6th led ash is for Pioneer and Jensen
7th led ash is for Alpine*
8th led ash is for Visteon
9th led ash is for Valor
10th Clarion 5V
* Note: If the ASWC ashes 7 times and you do not have an Alpine
radio connected to it that means that the ASWC did not see any radio
connected. Verify the 3.5mm connector is connected to the SWC input on
the radio.
6. Once the radio manufacturer has been selected hold Volume Down
for at least 5 seconds. The led will ash the number of times which
radio was selected then the led will remain on to indicate the ASWC
has nished programming.
7) Go enjoy your radio.