Filter
Top Products
16
©
2000 Directed Electronics, Inc.
as soon as the parking lights flash. If the buttons are pressed
longer than two seconds, the remote start sequence will stop.
About three seconds after the parking lights flash, the system will
engage the starter until the vehicle is successfully running. If the
motor is not running after six seconds, the system will stop crank-
ing the starter. After three seconds, the system will attempt to
start the motor again. If your motor is not running after three
attempts, the system will stop the remote start sequence. It is not
necessary to disarm your system before remote starting the vehi-
cle. The shock sensor will be bypassed whenever the system is run-
ning the motor.
IMPORTANT! It is unsafe to operate a vehicle’s motor in a garage or other
closed off area. Breathing the exhaust from the vehicle is hazardous to
your health. Never activate the remote start in an enclosed space.
Once the remote start system has successfully started the motor, it
will turn the climate controls on. The motor will run for the select-
ed period of time and the parking lights will flash or light solid
while the motor is running. (See Programming Options Section of
this guide.)
Pressing and again, during remote start operation, will
shut down the remote start system and the motor will turn off. You
can also shut down the remote start system by pressing on the
brake pedal. You may want to enter the vehicle and drive it with-
out shutting off the motor. It is possible to shut down the remote
start and drive the vehicle without shutting down the motor.
Shutting Down The Remote Start System