Filter
Top Products
13
©
2000 Directed Electronics, Inc.
If your remote transmitter is lost or damaged, you can manually
disarm your vehicle security system. To disarm the system without
a transmitter, you must have the vehicle's ignition key and know
where the Valet
®
switch is located. Be sure to check with your
installer at the time of installation for both the location and the
preset response (1-5 presses) of the Valet
®
switch.
To disarm the security system,
turn the ignition key on and
press the Valet
®
switch the
preset number of times within
15 seconds. If the system does
not disarm, you may have
waited too long; turn the igni-
tion off and repeat the process.
IMPORTANT! The Valet
®
switch can be programmed to respond to 1-5
presses for the disarm function. You must check with the installer to ver-
ify the programming for your individual unit.
LOCATION OF VALET
®
SWITCH_____________________________
Use the Silent Mode to temporarily turn off the arm or disarm con-
firmation chirps by briefly pressing before either arming or dis-
arming the security system. The confirmation chirp(s) will then be
eliminated for that one operation only. To permanently turn off the
arm and disarm confirmation chirps, contact your installation dealer.
Silent Mode
DRW-35
Disarming Without a Transmitter