Filter
Top Products
Note: Pressing the
LOCK and UNLOCK buttons at the same time will activate the AUX 2 output.
Remote-starting Your Vehicle
Remote-starting
Press the START/STOP button for approx. 1 second. The parking lights will come ON,
informing you that the unit has received your signal. The engine will start
approx. 5 seconds later. The parking lights will remain ON during the pre-programmed run
time.
If the vehicle doesn’t start at the first attempt, the system will shut down, wait a few
seconds, and try to start the engine again. It will try to start the engine 3 times before
giving up.
Setting the system to Ready Mode
This unit is designed for Manual Transmissions only. In order to remote-start the
vehicle, the Unit must first be set to Ready mode. If the Unit is not set to Ready Mode, it
cannot remote-start the vehicle. Once the system has been set to Ready Mode, the
vehicle can be remote started and stopped at will (as long as the Unit never exits Ready
Mode).
1. Ensure that all the Doors are closed and that the Gear Lever is in the Neutral
position.
2. With the Engine already running, apply the Parking Brake.
3. Within 20 sec. press LOCK, UNLOCK or START/STOP on the Transmitter.
The Parking Lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
6. Press either:
a. LOCK to lock the Doors, arm the Alarm and shut down the Engine;
b. UNLOCK to unlock the Doors and shut down the Engine;
c. START/STOP to shut down the Engine without affecting the Doors or;
d. TRUNK to lock all Doors and engage idle mode.
Remaining in Ready Mode
Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However,
if any one of the following events occurs, the vehicle will exit Ready Mode – thus
eliminating the remote start option until Ready Mode is restored:
CT-5060 User Guide P. 2