Filter
Top Products
User Guide P. 9
“ALARM”, “Time” (the moment the Alarm was triggered) and “DOOR/HOOD/TRUNK/SHOCK”
(depending on the type of alarm) alternately. The icons of door, hood, trunk and shock, as well as
the red backlight, will be flashing (when the
BLITE is set ON).
Alarm Type LCD Text Icon
Sound or
Vibration
DOOR ALARM + DOOR
Car front view outline +
door open and close
60 seconds
HOOD ALARM + HOOD
Car side view outline +
hood up and down
60 seconds
TRUNK ALARM + TRUNK
Car side view outline +
trunk lid up and down
60 seconds
SHOCK ALARM + SHOCK
Car front view outline +
lightning rods flashing
60 seconds
IGNITION ALARM + real time NONE 60 seconds
The user can press the LOCK or UNLOCK button to stop the alarm (unless DUAL-STAGE Mode has
been programmed – one press then only mutes the siren; the user needs to press twice in order to
disarm the system).
Passive Arm Mode
In passive arming mode, the system will arm itself automatically after the completion of a 1-min.
arming delay (LED flashes quickly), initiated after the last door of the vehicle is closed. Therefore,
you do not need to arm the system. The LED indicator flashes slowly when the system is armed.
However, you must lock your doors manually when leaving the vehicle.
When leaving your vehicle, perform the following:
1. Turn the key switch off. The LED remains off.
2. Unlock if required and open the doors.
3. Once all doors are closed after exiting the vehicle, the LED will begin to flash quickly,
indicating that passive arming delay has begun.
Also, as long as a door, trunk or hood is open before the completion of the arming delay, the
system will not rearm. If you want to stay in the vehicle for a certain period of time, it is
recommended to have your key switch in the
ON position to avoid a situation where the system
arms before somebody leaves the vehicle. While your key is in the
ON position, the system will not
arm and the LED will stay off.
For the two-way LCD remote, once the system is armed automatically, the “
LOCK” will be displayed
for 1 minute, and the icon will be on the LCD screen.
Active Arm Mode
To arm the system and lock your doors (if you have this option), the ignition must go from ON to
OFF and a door has to be opened and then closed. Press the LOCK button on your remote until the
siren chirps once in confirmation. Notice that the parking lights confirm the system arming by
flashing once and that the LED indicator flashes slowly to confirm the armed state, or that the
I icon is on the LCD screen (for the 2-way remote).