Filter
Top Products
User Guide P. 9
Vehicle Presets
Heater & Heated Seats
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan) as well as heated seats (if equipped) should
not be left on
HIGH. It is recommended to leave the settings on LOW or MEDIUM instead.
Windshield Wipers, Radio & Headlights
Certain vehicles energize the radio and / or windshield wipers and / or headlight circuits while
running under remote start. When leaving the vehicle you must ensure that the windshield wiper
and headlight switches are
OFF. Leaving the headlight switch ON on certain types of vehicles could
cause them to remain
ON even after remote starter shut down, resulting in a dead battery.
Driving Off
With the vehicle running under remote start, press the UNLOCK button to disarm the security system
(this will also unlock the doors). Enter the vehicle and do the following:
1. Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK
position while the engine is running. This will cause the starter motor to re-engage.)
2. Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Using the Remote Starter
Arming and Disarming the Security System
To disarm the alarm and Starter Kill (if installed) and unlock the doors (if installed):
1. Press and hold the UNLOCK button for approx. 1 sec.
You will hear two chirps if the Siren or Horn is so configured.
2. The UNLOCK button will light up on the LED display of the remote control. The parking lights
will flash twice and the LED will go out to confirm that the doors have been unlocked (the
starter kill (if installed) and the alarm will disarm as well). Turning the ignition ON and OFF will
reset the alarm memory.
In Passive Mode, the system will rearm automatically 30 seconds after the key is taken out of the
ignition (or was not turned to the ON position and the last door was closed). If the vehicle was
remote started, the break pedal must be pressed in order to allow the unit to detect that the user
has taken over control of the vehicle. This will stop the sequence for passive rearm.
To arm the alarm and Starter Kill (if installed) and lock the doors (if installed):
1. Press and hold the lock button for approx. 1 sec.
You will hear one chirp if the Siren or Horn is so configured.
2. The LOCK button will light up on the LED display of the remote control. The parking lights will
flash once and the LED will flash slowly to confirm that the doors have been locked (the
Starter Kill (if installed) and the alarm will arm as well).
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.